Aller au contenu principal

Modifications apportées à l'étape #2

Modifié par Kevin Green

Modification approuvée par Kevin Green

Supprimé(e)
Ajouté(e)
Inchangé

Lignes de l'étape

[* black] Using a flat head screwdriver, carefully pry up the beige ribbon connectors and remove the wires from them.
[* black] Use a slightly upward force with the screwdriver as parallel to the ground as possible.
[* icon_note] Be sure to make a mental note or jot down the locations of the specific ribbon cables. Some are in close proximity to each other and it can be easy to forget which ribbon goes where.
[* black] Use a slightly upward force with the screwdriver as parallel[* red] Be sure to the ground as possible.
[* black] Don't forget about
unplug the smaller ribbon that connects to a different part of the circuitrycircuit board.
[* icon_caution] Take care not to use too much force. The connectors are fragile andfragile, the ribbon wires are easily bent, and too much force may damage the circuit board if you happen to miss.
[* black] Use a slightly upward force with the screwdriver as parallel[* red] Be sure to the ground as possible.
[* black] Don't forget about
unplug the smaller ribbon that connects to a different part of the circuitrycircuit board.
[* icon_caution] Take care not to use too much force. The connectors are fragile andfragile, the ribbon wires are easily bent, and too much force may damage the circuit board if you happen to miss.

Image 2

Ancienne version

Nouvelle version