Aller au contenu principal

Modifications apportées à l'étape #9

Modifié par drmdolfan

Modification approuvée par drmdolfan

Avant
Après
Inchangé

Lignes de l'étape

+[title] Close, Seal and Test
+[* black] Line up and apply the ribbon cable tape over the cable and ZIF connectors. The tape looked a bit tattered which is why I would prefer to use new tape.
+[* black] Line up the display over the watch body and press the display onto the body and press along the edges so that everything is aligned and sealed.
+[* black] In the event that you have to reopen the watch after the new force touch gasket has been sealed to the display and to watch body, use a bead of B-7000 on the gasket and apply some light holding pressure for several hours. Remove any excess adhesive immediately from the watch.
+[* black] Charge the watch and test everything. I did a complete factory reset and then paired the watch and loaded WatchOS 5.

Image 1

Aucune image précédente

Ajouté

Image 2

Aucune image précédente

Ajouté

Image 3

Aucune image précédente

Ajouté