Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Modifications apportées à l'étape #4

Modifié par Philip Le Riche

Modification approuvée par Philip Le Riche

Avant
Après
Inchangé

Lignes de l'étape

[* black] To test the motor, unsolder the connections and attach jumper leads. Touch these very briefly on the terminals of the battery. If the motor fails to turn, disconnect the battery immediately as there may be a short circuit.
[* black] If you need to disassemble the motor, first make a mark on the steel case next to the terminal marked "+". If you reassemble it the wrong way round the motor will turn in the wrong direction.
[* black] prise up the two metal tabs at the back of the steel case. The magnets will resist the rotor being withdrawn, so push the spindle into and through the front bearing rather than pulling on the nylon rear piece, otherwise you may distort the brush springs.
[* black] Inspect the commutator with a magnifying glass. Check for any slivers of copper which might be creating a short between any two segments. Clean in with isopropyl alcohol and an old toothbrush.

Image 1

Aucune image précédente

Ajouté

Image 2

Aucune image précédente

Ajouté