Modifications apportées à l'étape #4
Modifié par Daniel Ulyanchuk —
Modification approuvée par Daniel Ulyanchuk
- Avant
- Après
- Inchangé
Lignes de l'étape
| + | [* black] Next, we will remove the rear light. Single cab trucks will not have this light, so if you don’t, skip this step and move onto step 5. |
|---|---|
| + | [* black] This light is held in place by one clip. To put it in, you slide the wider side in, and push up on the thinner side to push the clip into place. To remove it, use a flathead screwdriver to gently pry the thinner side down, gradually applying more pressure until it springs out. |
| + | [* black] Next, disconnect the wiring by squeezing both nobs on the wiring end, and pulling away from the light. The wiring will pop out. |