Aller au contenu principal

Modifications apportées à l'étape #1

Modifié par Jozsef

Modification rejetée par Jake Devincenzi

Avant
Après
Inchangé

Lignes de l'étape

[* icon_reminder] Flip the Apple TV over so that the bottom of the unit is facing up.
[* icon_note] You need to remove the rubber base to get access to the screws.
-[* black] Starting at one side of the device, use a hairdryer or a heat gun to soften the adhesive holding the rubber base in place.
-[* icon_caution] The rubber base will be hot after heating, take extreme while proceeding.
+[* black] Starting at one side of the device, use a hair dryer or a heat gun to soften the adhesive holding the rubber base in place.
+[* icon_caution] The rubber base will be hot after heating, take extreme care while proceeding.
[* black] While the adhesive is still warm, peel the bottom of the rubber base upwards to detach it from the metal plate.
[* black] Repeat the procedure described above until the rubber base has been completely removed.