Modifications apportées à l'étape #1
Modifié par Meagan Tobias —
Modification approuvée par Meagan Tobias
- Avant
- Après
- Inchangé
Lignes de l'étape
| [title] Assembling the Sensor | |
| [* red] Attach aluminum strut channels to the sontek sensor using strut channel nuts, washers, and 3/8" bolts | |
| + | [* icon_note] You only need one strut channel on the side of the sensor that must connect to the vertical strut channel. The other side was removed during deployment. |
| + | [* violet] Feed the conduit over the sontek connection cable to protect it when in the river. It will not make a physical connection to the sensor |
| [* orange] Screw the water tight sontek connection cable into the connection port. | |
| - | [* violet] Feed the conduit over the sontek connection cable to protect it when in the river. It will not make a physical connection to the sensor |
| - | [* yellow] Screw the conduit into the base of the node box with the sontek connection wire fed through it |
| - | [* icon_note] You only need one strut channel on the side of the sensor that must connect to the vertical strut channel. The other is only for stability and protection in the water. |
| + | [* yellow] Screw the other end of the conduit into the base of the node box with the excess sontek wire pulled through. |