Réparez vos affaires Communauté Boutique

Modifications apportées à l'étape #1

Modifié par Sarah Westberg —

Modification approuvée par Sarah Westberg

Avant
Après
Inchangé

Lignes de l'étape

-[* black] After the plugs and screws are removed from the cover, grab a heat gun and turn it on with low heat
-[* black] Around the edges of the speaker is adhesive which holds it in place. The heat gun will warm the adhesive, allowing you to remove it from the cover.
+[* icon_note] This next step requires the use of a heat gun or hair dryer. Follow this [guide|151116|guide|new_window=true] for more information on using a heat gun.
+[* black] Use a heat gun on low, around the edges of the speaker to loosen adhesive that holds it in place.
[* black] Point it down on the speaker at a distance of about 2-4 inches while moving in a circular motion around the edges of the speaker. Do this for about 30 seconds.
-[* black] Turn off the heat gun and set it aside. Using a plastic spudger, position under the edges of the speaker and gently work around it until it is free from the cover.
+[* icon_caution] Use caution when using a heat gun. The barrel of a heat gun gets very hot. If used incorrectly, you could burn yourself or possibly even damage the device.
+[* black] Turn off the heat gun and set it aside.
+[* black] Use a plastic spudger and position it between the edges of the speaker and the black case. Gently work the spudger around the perimeter of the speaker until it is free from the cover.
[* black] Once the speaker isn't being held down by adhesive, gently pull the speaker out.
-[* icon_caution] Use caution when using a heat gun. The barrel of a heat gun gets very hot. If used incorrectly, you could burn yourself or possibly even damage the device.