Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Modifications apportées à l'étape #12

Modifié par Nick

Modification approuvée par Nick

Avant
Après
Inchangé

Lignes de l'étape

[title] IdentifyRemove the power supply
[title] IdentifyRemove the power supply
[* icon_caution] '''If you see bulged capacitors, treat them as if they have residual charge. This may mean discharging them as a safety precation.'''
[* icon_caution] '''In most cases, the filter capacitor does NOT need to be replaced. If you need to replace this capacitor, discharge it before replacement.'''
[* icon_caution] '''Original capacitor ratings (primary): 25V 1000uF (X2), 10V 1000uF (X1), 25V 220uF (X2)'''The black screw (marked in Blue) is a ground screw. It does not go anywhere else. It is also important that you avoid losing this screw.'''
[* icon_reminder] Only lift the power supply board at a slight angle. Lifting it any more then this could result in pin or video processing board damage.
[* icon_caution] '''Original capacitor ratings (primary): 25V 1000uF (X2), 10V 1000uF (X1), 25V 220uF (X2)'''The black screw (marked in Blue) is a ground screw. It does not go anywhere else. It is also important that you avoid losing this screw.'''
[* icon_reminder] Only lift the power supply board at a slight angle. Lifting it any more then this could result in pin or video processing board damage.
[* icon_reminder] If you cannot find the original capacitors, it is okay to substitute the original capacitors with larger replacements. It is not necessary to match the capacitors used by the factory.
[* red] This capacitor is only used on older power supply boards. If your board has this capacitor, replacement is recommended but is generally not required unless there is obvious bulging or leakage.
[* black] With the power supply shield removed from the monitor, identify the power supply. Along with the capacitors previously mentioned, take note of any additional capacitors that were not mentioned (ex: Capacitor by the inverter coil).
[* black] Remove the 4 screws from the power supply. Once this is done, lift the power supply up at a slight angle to clear the mounting holes so you can remove the power supply from the monitor.

Image 1

Ancienne version

Nouvelle version

Image 2

Aucune image précédente

Ajouté

Image 3

Aucune image précédente

Ajouté