Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Modifications apportées à l'étape #12

Modifié par Nick

Modification approuvée par Nick

Avant
Après
Inchangé

Lignes de l'étape

[title] Remove the power supply
[* icon_caution] '''If''If you see bulged capacitors, assume there is a residual charge. Treattreat the power supply accordingly.as if the capacitors are holding a residual charge.'''''
[* icon_caution] '''In''In most cases, the filter capacitor does NOT need to be replacedis okay. If this capacitorit is replacedreplace, it MUST be discharged.discharged first.'''''
[* icon_caution] '''The''The black screw (marked in Blue) is a ground screw and only fits in one holehere. DO NOT lose this screw.it.'''''
[* icon_caution] '''If''If you see bulged capacitors, assume there is a residual charge. Treattreat the power supply accordingly.as if the capacitors are holding a residual charge.'''''
[* icon_caution] '''In''In most cases, the filter capacitor does NOT need to be replacedis okay. If this capacitorit is replacedreplace, it MUST be discharged.discharged first.'''''
[* icon_caution] '''The''The black screw (marked in Blue) is a ground screw and only fits in one holehere. DO NOT lose this screw.it.'''''
[* icon_reminder] Only lift the power supply board at a slight angle. Lifting it any more then this could result in pin or video processing board damage.
[* icon_reminder] If you cannot find the original capacitors, it is okay to substitute the original capacitors with larger replacements. It is not necessary to match the capacitors used by the factory.
[* red] This capacitor is only used on older power supply boards. If your board has this capacitor, replacement is recommended but is generally not required unless there is obvious bulging or leakage.
[* black] With the power supply shield removed from the monitor, identify the power supply. Along with the capacitors previously mentioned, take note of any additional capacitors that were not mentioned (Ex: inverter coil).
[* black] Remove the 4 screws from the power supply. Once this is done, lift the power supply up at a slight angle to clear the mounting holes so you can remove the power supply from the monitor.