Aller au contenu principal

Modifications apportées à l'étape #3

Modifié par Jeff Suovanen

Modification approuvée par Jeff Suovanen


Lignes de l'étape

+[* black] Two clips secure the RAM module in place, one on each side. Using your fingers, spread the clips away from the RAM module.
+ [* black] When released, the RAM module will pop up at a slight angle.
+[* black] Lift the RAM module to an angle of about 30 degrees and slide it out.
+ [* black] When handling the RAM module, touch only the outside edges. Take care not to touch the gold-colored contact points along the bottom edge.
+ [* black] To install a new RAM module, slide it in place at about the same angle until it is snug, and then swing it downward until the two clips snap into place.