Aller au contenu principal

Modifications apportées à l'étape #3

Modifié par Thomas J

Validation en attente

Avant
Après
Inchangé

Lignes de l'étape

-[* black] If can't find anything suitable in the internet, I'll give you a few tips how to build a screwdriver on your own.
-[* black] Use a steel rod of about 8 mm diameter. Don't use any weaker metals
-[* black] Now try to mill three teeth with equivalent distanze around the boundary of one end of the rod with an angle grinder. After you made this drill a hole perpendicularly in the center of the rod.
-[* black] With some talent you should now have a reasonable screwdriver for the four most terrible screws I've ever seen.
-[* black] Now can start with the actual teardown.
+[* black] I couldn't find anything suitable in the internet, so I built one on my own in this way:
+[* black] Using a steel rod of about 8 mm diameter.
+[* black] I tried to mill three teeth with equivalent distance around the boundary of one end of the rod with an angle grinder. After that I drilled a hole perpendicularly in the center of the rod. Taddaah... a working screwdriver!
+[* black] Now let's begin the Teardown.