| - | [* violet] Finally remove screws (Type T point, Phillips Truss head screw) holding down the power cord. Cut off all wires. |
|---|
| - | [* light_blue] This is the Rotary Switch that connects the dial and heating device. It has a bare shift actuator and I couldn't get it open but most likely houses the PCB board. |
|---|
| + | [* violet] Finally I removed the 2 screws (M2 x 1mm Phillips Head Screw) holding down the power cord. Cut off all wires. |
|---|
| + | [* light_blue] This is the Rotary Switch that connects the dial and heating device. It has a bare shift actuator and I couldn't get it open but most likely houses the PCB. |
|---|