Aller au contenu principal

Modifications apportées à l'étape #13

Modifié par Rylan Luke

Modification approuvée par Rylan Luke

Avant
Après
Inchangé

Lignes de l'étape

+[* black] OPTIONAL: Install missing components. This requires purchase of additional components from mouser.com. See the guide parts list for more info. The image shows the location of the new components; you'll also need to install IC307.
+[* black] Seriously, though, if you're going to add the missing components, buy the schematic online so that you have the PCB layout and schematic available for reference.
+[* black] It is difficult to solder these components in place, due to the large nearby cap (C382). I removed it before installing the missing components, and then reinstalled it, although the ground plane made this difficult to unsolder.
+[* black] You also MUST remove the 4 zero ohm resistors (as shown with a red line through them in the image).
+[* black] There is one additional step to take: disable the power amp. This is done by removing the main board from the lower case, and shorting together pins 2 and 4, to hold the power amp in standby. This step is not necessary if the missing components are not installed.

Image 1

Aucune image précédente

Ajouté