Aller au contenu principal

Modifications apportées à l'étape #2

Modifié par Richdave

Validation en attente

Supprimé(e)
Ajouté(e)
Inchangé

Lignes de l'étape

[* blackicon_caution] Voltages are all measured with PIN 1 as reference. Pin 1 is marked on the board by a dot and is the right hand pin when viewed as shown in photos
[* blackred] Pin 5 is the PSU enable line - Logic board pulls this line low (0V) to enable PSU (probably via a resistor)
[* blackicon_caution] Voltages are all measured with PIN 1 as reference. Pin 1 is marked on the board by a dot and is the right hand pin when viewed as shown in photos
[* blackred] Pin 5 is the PSU enable line - Logic board pulls this line low (0V) to enable PSU (probably via a resistor)
[* black] Pin 4 voltage varies and is inversely proportional to PSU temperature. Higher Temp = Lower voltage. My measurement was taken at around **24 Deg Celsius.