Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Modifications apportées à l'étape #1

Modifié par Matthew Newsom

Validation en attente

Avant
Après
Inchangé

Lignes de l'étape

[* red] Unsolder bothicon_note] The battery on the Shuffle is attached via solder joints connectingpads with small holes that go through the battery ribbon cable and attach to flat pads on the face of the logic board. In this step, you will heat each solder pad individually while using a spudger to pry it up from the logic board.
[* black] Removeicon_caution] DO NOT bridge the battery fromconnection between the solder pads on the board. Shorts have the potential to ruin the logic board.
[* black] Toicon_caution] Beware of overheating the board and the cable. Only hold the tip of the iron against the pad long enough to let the solder a new batterymelt. Excess heat buildup has the potential to ruin the logic board, followboard or melt the [guide|750|repairing soldered connections guide]ribbon cable.
[* black] Start working from the right side of the battery ribbon cable. Heat the rightmost solder pad while gently prying up from under the ribbon cable to free it from the board
.
[* red] Unsolder bothicon_note] The battery on the Shuffle is attached via solder joints connectingpads with small holes that go through the battery ribbon cable and attach to flat pads on the face of the logic board. In this step, you will heat each solder pad individually while using a spudger to pry it up from the logic board.
[* black] Removeicon_caution] DO NOT bridge the battery fromconnection between the solder pads on the board. Shorts have the potential to ruin the logic board.
[* black] Toicon_caution] Beware of overheating the board and the cable. Only hold the tip of the iron against the pad long enough to let the solder a new batterymelt. Excess heat buildup has the potential to ruin the logic board, followboard or melt the [guide|750|repairing soldered connections guide]ribbon cable.
[* black] Start working from the right side of the battery ribbon cable. Heat the rightmost solder pad while gently prying up from under the ribbon cable to free it from the board
.