Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Modifications apportées à l'étape #1

Modifié par David Hodson

Validation en attente

Avant
Après
Inchangé

Lignes de l'étape

[* icon_note] The battery on the Shuffle is attached via solder pads with small holes that go through the battery ribbon cable and attach to flat pads on the face of the logic board. In the following steps you will heat each solder pad individually while using a spudger to pry it up from the logic board.
[* icon_caution] DO NOT bridge the connection between the solder pads on the board. Shorts have the potential to ruin the logic board.
[* icon_caution] Beware of overheating the board and the cable. Only hold the tip of the iron against the pad long enough to let the solder melt. Excess heat buildup has the potential to ruin the logic board or melt the ribbon cable.
[* black] Start working from the right side of the battery ribbon cable. Heat the rightmostright solder pad while gently prying up from under the ribbon cable to free it from the board.
[* black] Start working from the right side of the battery ribbon cable. Heat the rightmostright solder pad while gently prying up from under the ribbon cable to free it from the board.