Modifications apportées à l'étape #6
Lignes de l'étape
| + | [* black] Carefully lift and turnover the LCD Screen so that you are able to see the motherboard. |
|---|---|
| + | [* icon_caution] Treat the motherboard with care since it is very sensitive to static discharge. Remain grounded to avoid the release of static discharge by wearing a static bracelet. |
| + | [* red] Carefully disconnect the LCD Screen ribbon cable away from its ZIF connector with your thumb and index finger. You must make sure to have your thumb and index finger cover as much of the ribbon's width and as close to the ZIF connector as possible without touching the motherboard while pulling the ribbon out. line. |
| + | [* icon_caution] Be careful to not rip the ribbon wire when pulling it out. |
| + | [* orange] Use the soldering iron to separate the black and red power wires from the motherboard. |
| + | [* icon_note] Make sure to note the location of where each wire was attached to. The black wire is the negative power wire and the red wire is the positive power wire. |
| + | [* icon_caution] Not knowing where the power wires go could disrupt the power distribution and lead to power outages and damage to the motherboard. |
Image 1
Aucune image précédente
Ajouté
Image 2
Aucune image précédente
Ajouté
Image 3
Aucune image précédente
Ajouté