Aller au contenu principal

Modifications apportées à l'étape #2

Modifié par Richard Gonzalez

Validation en attente

Supprimé(e)
Ajouté(e)
Inchangé

Lignes de l'étape

[* black] Reorient the camera so it is upright and you are looking at the back screen.
[* red] Remove the rubber covers in the upper and lower right side corners. Insert spudger in between the camera case and the rubber cover and push them out of their sockets. Grab the rubbers with the tweezers and set them aside. Remove both of the 4.3 mm silver screws revealed.
[* orange] Remove the 4.3 mm silver screw in the lower left corner which resides under the sliding battery cover.
[* red] Remove the rubber covers in the upper and lower right side corners. Insert spudger in between the camera case and the rubber cover and push them out of their sockets. Grab the rubbers with the tweezers and set them aside. Remove both of the 4.3 mm silver screws revealed.
[* orange] Remove the 4.3 mm silver screw in the lower left corner which resides under the sliding battery cover.
[* icon_note] When removing the screw in the lower left corner, you may need to gently pry open the casing to dislodge the screw.