Aller au contenu principal

Modifications apportées à l'étape #2

Modifié par KarlD

Validation en attente


Lignes de l'étape

[* icon_note] Do not lift the logic board out completely without first disconnecting the DC-In connector underneath the logic board.
[* black] Lift the logic board partly up from the optical side.
[* black] When reassembling, make sure the black wire at the top of the logic board is not folded before being routed up through the indent at the top middle left of the logic board. If this is the case, the wire will be too short for later reassembly steps.