Modifications apportées à l'étape #3
Modifié par David Hodson —
- Avant
- Après
- Inchangé
Lignes de l'étape
[* icon_note] This step is for removing the brake drum and the wheel bearing together. |
[* black] Use a hammer and a flat head screwdriver to make a small indentation along the edge of the wheel bearing dust cap. |
[* black] Pry the dust cap out of the brake drum with the flat head screwdriver. |
[* red] Remove the 29 mm rear hub bolt nut from the brake drum. This will require either a breaker bar or an impact wrench. |
[* icon_note] This nut is torqued to 175 ft-lbs, and should not be removed more than four times. Use a permanent marker to make a mark on the nut each time it is removed. |
Image 1
Aucune image précédente
Ajouté
Image 2
Aucune image précédente
Ajouté
Image 3
Aucune image précédente
Ajouté