Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Modifications apportées à l'étape #3

Modifié par David Hodson

Validation en attente

Avant
Après
Inchangé

Lignes de l'étape

[* icon_note] This step is for removing the brake drum and the wheel bearing together.
[* black] Use a hammermallet and a flat head screwdriver to make a small indentation along the edge of the wheel bearing dust cap.
[* black] Use a hammermallet and a flat head screwdriver to make a small indentation along the edge of the wheel bearing dust cap.
[* black] Pry the dust cap out of the brake drum with the flat head screwdriver.
[* red] Remove the 29 mm rear hub bolt nut from the brake drum. This will require either a breaker bar or an impact wrench.
[* icon_note] This nut is torqued to 175 ft-lbs, and should not be removed more than four times. Use a permanent marker to make a mark on the nut each time it is removed.