Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Modifications apportées à l'étape #2

Modifié par Julia

Modification approuvée par Julia

Avant
Après
Inchangé

Lignes de l'étape

[* icon_note] Support the display with one hand as you remove the remaining T8 screws.
[* red] Remove the upper two full thread 10 mm T8 Torx screws from each side of the display, then the two lower shanked 13 mm screws (four screws total).
[* icon_reminder] When replacing the display, make sure that the correct screw pins down the ground loop from the display data cable.
[* black] Disconnect the two antenna cables from the airport/bluetooth card (shown in yellow circles), as well as the display cable (wide connector right hand upper corner) and the cable on top left corner of the logic boardboard (shown in blue square).
[* black] Disconnect the two antenna cables from the airport/bluetooth card (shown in yellow circles), as well as the display cable (wide connector right hand upper corner) and the cable on top left corner of the logic boardboard (shown in blue square).

Image 1

Ancienne version

Nouvelle version