Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Modifications apportées à l'étape #2

Modifié par sieg deleu

Validation en attente

Avant
Après
Inchangé

Lignes de l'étape

[* icon_note] Support the display with one hand as you remove the remaining T8 screws.
[* red] Remove the twofour T8 Torx screws from each side of the display.
[* red] Remove the twofour T8 Torx screws from each side of the display.
[* icon_reminder] When replacing the display, make sure that the correct screw pins down the ground loop from the display data cable.
[* black] Disconnect the two antenna cables from the airport/bluetooth card (shown in yellow circles)circles), as well as the display cable (wide connector right hand upper corner) and the cable on top left corner of the logic board.
[* black] Disconnect the two antenna cables from the airport/bluetooth card (shown in yellow circles)circles), as well as the display cable (wide connector right hand upper corner) and the cable on top left corner of the logic board.