Aller au contenu principal

Modifications apportées à l'étape #2

Modifié par Phillip Takahashi

Validation en attente

Avant
Après
Inchangé

Lignes de l'étape

+[* black] Starting with the battery cell closest to the dock connector, run a plastic opening tool underneath the edge of the battery closest to the logic board void to make enough room to insert the flat end of a spudger
+[* black] Run the flat end of a spudger along the two long sides of each battery cell to completely separate them from the adhesive securing them to the rear case.
+[* black] If the adhesive is very difficult to separate, reheat the rear panel and try again.

Image 1

Aucune image précédente

Ajouté

Image 2

Aucune image précédente

Ajouté