Aller au contenu principal

Modifications apportées à l'étape #5

Modifié par Andrew Bookholt

Validation en attente

Supprimé(e)
Ajouté(e)
Inchangé

Lignes de l'étape

[* icon_note] DisconnectingThe logic board is still connected to the front case by the following twodisplay ribbon cables may be challenging. To prevent strainingcable, located on the cables or connectors, you can only separateheadphone jack side of the two halveslogic board. When lifting the logic board out of the iPodfront case, do so as you would open a book by rotating the board about 1/2 inch during the processdisplay ribbon cable.
[* black] Use a spudger to slideLift the logic board from the click wheel connector side (the cable out of its connectoryou just disconnected) and lay the logic board next to the front case.
[* icon_note] DisconnectingThe logic board is still connected to the front case by the following twodisplay ribbon cables may be challenging. To prevent strainingcable, located on the cables or connectors, you can only separateheadphone jack side of the two halveslogic board. When lifting the logic board out of the iPodfront case, do so as you would open a book by rotating the board about 1/2 inch during the processdisplay ribbon cable.
[* black] Use a spudger to slideLift the logic board from the click wheel connector side (the cable out of its connectoryou just disconnected) and lay the logic board next to the front case.

Image 1

Aucune image précédente

Ajouté(e)

Image 2

Aucune image précédente

Ajouté(e)