Aller au contenu principal

Modifications apportées à l'étape #2

Modifié par Phillip Takahashi

Validation en attente

Avant
Après
Inchangé

Lignes de l'étape

[* black] Remove the T9 Torx screw securing the Bluetooth board to the case.
[* icon_caution] Do not attempt to completely remove the board yet, as it is still attached by a cable.
-[* black] Remove the tape encasing the bluetooth board, being careful not to put to much tension on the still connected cable.
-[* black] Use a spudger to disconnect the bluetooth data cable and remove the bluetooth board.
+[* black] Remove the tape wrapped around the Bluetooth board, being careful not to put to much tension on the still connected cable.
+[* black] Use the flat end of a spudger to pull the Bluetooth data cable out of its connector and remove the Bluetooth board.