Historique de l'étape n° 4 de Emson Star Wars R2-D2 Humidifier LED Replacement

Modifications apportées à l'étape #4

Modifié par Marcos Serrano — 23 avr. 2017

Modification approuvée par Marcos Serrano

	[* black] Lay the bottom part of the device upside down on a table.
	[* red] Locate the four PH1 screw heads on the underside.
-	[* black] ~~In our guide, we used the IFIXIT pro tech toolkit.~~ We used the bit driver with a 4mm driver attachment to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image)
+	[* black] We used the bit driver with a 4mm driver(from IFIXIT pro tech toolkit) attachment to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image)
	[* black] *NOTE*: The PH1 screw heads are located 5cm into the device. Make sure to use a PH1 Driver that is 1cm in diameter and 5cm in depth.