Modifications apportées à cette étape
Modifié par Shannon Murphy —
- Avant
- Après
- Inchangé
Lignes de l'étape
| + | [* black] Place the battery in the rear panel with the cable side down. Use two small strips of electrical tape to hold down the cable against the solder pads. |
|---|---|
| + | [* black] Place a strip of tape over the end of the battery ribbon cable to cover two of the solder pads and hold the contacts down against the logic board. |
| + | [* black] Heat the rightmost contact until the solder melts. Apply a small amount of solder to the contact. Allow it to flow through the two holes in the cable and down to the logic board. |
| + | [* black] Do not apply to much of the solder. |
| + | [* black] Remove both the solder and the iron as soon as the solder has flowed into the joint. |