Aller au contenu principal

Introduction

The motherboard is the heart and soul of any electronic device. Learn how to replace it!

Pièces

Aucune pièce spécifiée.

  1. Remove the rubber foot pads on the bottom of the device using a plastic opening tool. Remove the rubber foot pads on the bottom of the device using a plastic opening tool.
    • Remove the rubber foot pads on the bottom of the device using a plastic opening tool.

  2. Remove the six 2 mm PH0 screws on the bottom of the device. Four of those screws are located under the foot pads.
    • Remove the six 2 mm PH0 screws on the bottom of the device.

    • Four of those screws are located under the foot pads.

  3. Gently remove the bottom of the device.
    • Gently remove the bottom of the device.

  4. Remove the four 1.8 mm J1 screws. Remove the two 2mm PH0 screws.
    • Remove the four 1.8 mm J1 screws.

    • Remove the two 2mm PH0 screws.

  5. Gently pick up the mother board
    • Gently pick up the mother board

    • Pick the mother board straight up or you may risk damaging the mini-USB charging ports.

  6. Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port. Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port.
    • Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Jacob

Membre depuis le 11/03/2015

750 Réputation

6 tutoriels rédigés

Équipe

Colorado Springs, Team 4-4, Panko Spring 2015 Membre de l'équipe Colorado Springs, Team 4-4, Panko Spring 2015

UCCS-PANKO-S15S4G4

3 membres

6 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 155