Aller au contenu principal
Aide

Nokia 8290 Vibrator Replacement

Use this guide to replace or repair your Nokia 8290's vibrator.

  • Auteur: Parker Niebauer
  • Durée estimée : 1 - 2 minutes
  • Difficulté: Modérée

Installing a new vibration component is necessary when the vibrate mode on your phone is no longer functioning properly. Installation requires no prior knowledge of mobile phone vibrators.

Sections
Outils

Étape 1 Vibrator  ¶ 

Remove all six 5.3 mm long T6 screws. Remove the circuit board/faceplate sub-assembly from the back of the phone. Take care to place screws in a safe location.

Étape 1 Vibrator  ¶ 

  • Remove all six 5.3 mm long T6 screws.

  • Remove the circuit board/faceplate sub-assembly from the back of the phone.

  • Take care to place screws in a safe location.

Étape 2  ¶ 

After removing the circuit board/faceplate sub-assembly, locate the vibrator mechanism. Remove the vibrator mechanism with tweezers by simply pulling it up and away from the phone. Remove the vibrator mechanism with tweezers by simply pulling it up and away from the phone.

Étape 2  ¶ 

  • After removing the circuit board/faceplate sub-assembly, locate the vibrator mechanism.

  • Remove the vibrator mechanism with tweezers by simply pulling it up and away from the phone.