Aller au contenu principal
Aide

JBL Pulse 2 Speaker Replacement

This guide will show you the steps necessary to replace the speakers for the JBL Pulse 2.

  • Auteur: Emilee Hicks
  • Durée estimée : 25 minutes
  • Difficulté: Modérée

If there is a problem with the audio of your JBL Pulse 2, you may need to replace the speakers. Replacing the speakers ensures that you receive the best listening quality when using your device.

Sections
Outils

Étape 1 Speaker  ¶ 

Remove the LED strips from the outside of the white plastic casing. Remove the LED strips from the outside of the white plastic casing. Remove the LED strips from the outside of the white plastic casing.

Étape 1 Speaker  ¶ 

  • Remove the LED strips from the outside of the white plastic casing.

Étape 2  ¶ 

Use the Phillips #1 screwdriver to remove the ten 9.5mm screws that hold the cage in place. Lift the cage off to access the internal components. Lift the cage off to access the internal components.

Étape 2  ¶ 

  • Use the Phillips #1 screwdriver to remove the ten 9.5mm screws that hold the cage in place.

  • Lift the cage off to access the internal components.

Étape 3  ¶ 

Use the Phillips #1 screwdriver to remove the eight 6.4mm screws that hold the speakers in place. Partially remove the speakers so that you can access the components underneath them.

Étape 3  ¶ 

  • Use the Phillips #1 screwdriver to remove the eight 6.4mm screws that hold the speakers in place.

  • Partially remove the speakers so that you can access the components underneath them.

Étape 4  ¶ 

Use the straight tweezers to disconnect the speakers from the motherboard. Fully remove the speakers once they are disconnected from the motherboard.

Étape 4  ¶ 

  • Use the straight tweezers to disconnect the speakers from the motherboard.

  • Fully remove the speakers once they are disconnected from the motherboard.