Aller au contenu principal
Aide

PSP 2000 Front Casing Replacement

  • Auteur: pepe32290
  • Durée estimée : 5 - 10 minutes
  • Difficulté: Facile

Paint job scratched? Going custom? Change out your faceplate assembly!

Étape 1 Front Casing  ¶ 

This step requires the removal of the warranty sticker. Removing the sticker will void the warranty.  According to the FTC removing this will not void your warranty.

Étape 1 Front Casing  ¶ 

  • This step requires the removal of the warranty sticker. Removing the sticker will void the warranty. According to the FTC removing this will not void your warranty.

  • Locate the sticker in the battery compartment labeled: "En: Warranty Void if Seal Damaged."

  • Remove the sticker using the PSP Opening Tools.

  • Under the sticker is a 5mm Phillips screw needed in the next step.

Étape 2  ¶ 

Remove four 5 mm Phillips from the case. If the screws stick in the case, you can use a magnetized screwdriver to draw them out.

Étape 2  ¶ 

  • Remove four 5 mm Phillips from the case.

  • If the screws stick in the case, you can use a magnetized screwdriver to draw them out.

Étape 3  ¶ 

Remove the following screws from around the bezel: Two 4 mm Phillips

Étape 3  ¶ 

  • Remove the following screws from around the bezel:

  • Two 4 mm Phillips

  • One 5 mm Phillips

  • The two shorter 4 mm screws are on the top of the PSP; the longer 5 mm screw is on the bottom.

Étape 4  ¶ 

Gently pry the front bezel away from the casing using a PSP opening tool. Start on the right hand side of the PSP bezel, and carefully work the tool around the side.

Étape 4  ¶ 

  • Gently pry the front bezel away from the casing using a PSP opening tool.

  • Start on the right hand side of the PSP bezel, and carefully work the tool around the side.

  • If you want to clean the control buttons or D-pad, you can easily pop them out once the faceplate is off and wipe them clean.