Aller au contenu principal
Aide

Disassembling Nintendo DS Lite Bottom Case

En cours

En cours

Ce tutoriel est en cours de réalisation. Actualisez-le régulièrement pour découvrir les dernières modifications !

Texte bizarre

Texte bizarre

Certaines parties de ce texte sont confuses, répétitives ou hors-sujet. Modifie-les pour les rendre plus claires !

Une étape a été sautée

Une étape a été sautée

Oups ! Il manque encore des étapes importantes à ce tutoriel.

Removal of the bottom cover.

  • Auteur: Brittany K
  • Durée estimée : 15 minutes
  • Difficulté: Difficile

This guide has been updated by iFixit staff! Read the new, official guide here.

This guide will show you have to remove the bottom cover of the DS Lite.

Étape 1 Disassembling Nintendo DS Lite Bottom Case  ¶ 

Remove the following 7 screws securing the lower case to the DS Lite:

Étape 1 Disassembling Nintendo DS Lite Bottom Case  ¶ 

  • Remove the following 7 screws securing the lower case to the DS Lite:

  • 3 silver tri-wing screws (5mm long)

  • 1 black tri-wing screw (4mm)

  • 2 gold Phillips screws (4mm)

  • 1 silver Phillips screw (3mm)

  • Do not remove the silver PH screw (3mm) in the battery compartment yet. It holds the main PCB in place.

Étape 2  ¶ 

Remove the plastic insert (or cartridge) from the lower slot (Slot 2).

Étape 2  ¶ 

  • Remove the plastic insert (or cartridge) from the lower slot (Slot 2).

Étape 3  ¶ 

Flip the unit over. Use a spudger to pry open the gap between the bottom case and the front panel.  Work all the way around the case until the panel is free.

Étape 3  ¶ 

  • Flip the unit over.

  • Use a spudger to pry open the gap between the bottom case and the front panel. Work all the way around the case until the panel is free.

  • Avoid touching the L and R shoulder buttons, because they pop off easily and are difficult to reassemble. Keeping the bottom case against your workbench will help hold them in place.

Étape 4  ¶ 

Carefully separate the two pieces by hand. The two shoulder buttons are made up of three pieces -- the plastic button, a pin, and a spring.  If they accidentally pop out while you are working, study the picture and make sure you put the spring in the correct position. When reassembling the cover, make sure that the power switch cover on the bottom case is in the off (down) position. Otherwise, the power switch cover can break the very fragile power switch upon reassembly.

Étape 4  ¶ 

  • Carefully separate the two pieces by hand.

  • The two shoulder buttons are made up of three pieces -- the plastic button, a pin, and a spring. If they accidentally pop out while you are working, study the picture and make sure you put the spring in the correct position.

  • When reassembling the cover, make sure that the power switch cover on the bottom case is in the off (down) position. Otherwise, the power switch cover can break the very fragile power switch upon reassembly.