Aller au contenu principal
Aide

Motorola Razr V3c Speaker (CDMA) Replacement

How to replace a Motorola Razr V3c speaker.

  • Auteur: Joshua Ruehlig
  • Durée estimée : 10 minutes
  • Difficulté: Modérée

This guide will show you how to remove and replace the speaker for a Motorola V3c.

Étape 1 Speaker (CDMA)  ¶ 

Unscrew the two screws in the back using the T6.

Étape 1 Speaker (CDMA)  ¶ 

  • Unscrew the two screws in the back using the T6.

Étape 2  ¶ 

Use the plastic opening tool to pop the bottom and the sides off the back casing.

Étape 2  ¶ 

  • Use the plastic opening tool to pop the bottom and the sides off the back casing.

  • Be careful not to pull the back lower cover off too far as it is connected to the phone body by a ribbon.

Étape 3  ¶ 

Peel off the connector between the motherboard and the body of the phone.

Étape 3  ¶ 

  • Peel off the connector between the motherboard and the body of the phone.

Étape 4  ¶ 

Pull out the two black rubber covers using tweezers. The second rubber cover is much harder to get out.

Étape 4  ¶ 

  • Pull out the two black rubber covers using tweezers.

  • The second rubber cover is much harder to get out.

Étape 5  ¶ 

Pull out the white plastic cover by unclipping the two plastic pieces shown. Pull out the white plastic cover by unclipping the two plastic pieces shown.

Étape 5  ¶ 

  • Pull out the white plastic cover by unclipping the two plastic pieces shown.

Étape 6  ¶ 

Pull out the speaker.

Étape 6  ¶ 

  • Pull out the speaker.