Toshiba Satellite P205-S8811 Monitor Replacement
A besoin de meilleures images
De meilleures photos amélioreront ce tutoriel. Aider en proposant de nouvelles photos!
This guide will demonstrate how to replace the monitor.
- Auteur: Bradley Johnson
- Durée estimée : 20 - 30 minutes
- Difficulté: Difficile
If your monitor is malfunctioning and/or needs to be replaced, follow the steps in this guide.
Intégrer ce tutoriel
Choisissez une taille et copiez le code ci-dessous pour intégrer ce tutoriel sous la forme d'un petit widget sur votre site / forum.
Étape 1 — Monitor ¶
Unscrew the 4mm Phillips #1 screw holding the hard drive cover on.
Place one finger underneath the tab of the hard drive cover and lift it up with medium force to take it off.
Étape 2 ¶
Grab the black tab attached to the hard drive and pull it to the left with a medium force until it pops out of its socket.
Étape 3 ¶
Remove the two 8mm Phillips #1 screws from the back side of the laptop.
Étape 4 ¶
Remove the four 8mm Phillips #1 screws located on the corners below the monitor.
Étape 5 ¶
Remove the two 4mm Phillips #1 screws located between the screws removed in the last step.
Étape 6 ¶
Unplug the black wire connecting the monitor to the motherboard by pulling it lightly towards you.
Unplug the black/red wire that also connects the monitor to the motherboard by pulling lightly away from you.
Étape 7 ¶
Remove the three colored wires (white, grey, and black) that are all connected beside each other by pulling them up lightly.
Étape 8 ¶
Gently pull out the wide, white wire coming from the monitor.
Étape 9 ¶
Use a plastic opening tool to loosen the top panel by placing the tool underneath the panel at several points and then lifting upwards with a medium force. You will know it is loose if it makes a loud clicking noise.
Place your fingers on the side of the panel closest to the monitor. Lift up on that side of the panel with a large amount of force in order to pry it off.
Étape 10 ¶
Remove the 8mm Phillips #1 screw located just below the large gray wire.
Remove the 8mm Phillips #1 screw located to the right of the left-hand speaker.
Remove the 4mm Phillips #1 screw located above the fan and next to the large gray wire.
Étape 11 ¶
Remove the large gray wire that is connected to the motherboard to the right of the fan.
Remove the small white/grey wire that is connected at the top of the fan.
Étape 12 ¶
Grabbing both sides of the monitor, gently lift the it out of place and set it aside.