Aller au contenu principal
Aide

MacBook Core Duo Optical Drive Replacement

Conditions préalables uniquement

Conditions préalables uniquement

Notez qu'il ne s'agit que de conditions préalables pour d'autres tutoriels.

  • Auteur: iRobot
  • Difficulté: Modérée

Access the combo or SuperDrive.

Sections

Étape 1 Optical Drive  ¶ 

Grasp the white plastic tab attached to the hard drive and pull it to the left, removing the hard drive from the computer.

Étape 1 Optical Drive  ¶ 

  • Grasp the white plastic tab attached to the hard drive and pull it to the left, removing the hard drive from the computer.

Étape 2  ¶ 

Remove the two Phillips screws from the front edge of the optical drive.

Étape 2  ¶ 

  • Remove the two Phillips screws from the front edge of the optical drive.

  • The shorter screw (3 mm) is recessed nearest the RAM modules. The other is 3.5 mm.

Étape 3  ¶ 

Disconnect the orange optical drive ribbon cable from the logic board.

Étape 3  ¶ 

  • Disconnect the orange optical drive ribbon cable from the logic board.

Étape 4  ¶ 

Disconnect the newly-revealed display data cable. If there is no pull-tab on the top of the connector, it may be helpful to use a spudger to disconnect this connector.

Étape 4  ¶ 

  • Disconnect the newly-revealed display data cable. If there is no pull-tab on the top of the connector, it may be helpful to use a spudger to disconnect this connector.

Étape 5  ¶ 

Disconnect the (once again) newly-revealed hard drive cable.

Étape 5  ¶ 

  • Disconnect the (once again) newly-revealed hard drive cable.

Étape 6  ¶ 

Peel up the foil tape between the fan and the optical drive.

Étape 6  ¶ 

  • Peel up the foil tape between the fan and the optical drive.

  • Remove the 8.5 mm Phillips screw securing the display data cable to the metal framework.

Étape 7  ¶ 

Pull up the display data cable from along the edge of the optical drive to reveal a silver Phillips screw.

Étape 7  ¶ 

  • Pull up the display data cable from along the edge of the optical drive to reveal a silver Phillips screw.

Étape 8  ¶ 

Remove the 2.8 mm Phillips screw securing the optical drive.

Étape 8  ¶ 

  • Remove the 2.8 mm Phillips screw securing the optical drive.

  • The Bluetooth cable may be covering the screw; carefully push it aside before removing the screw.

  • Do not over-tighten this screw when re-mounting. You could break the plastic enclosure.

  • After removing the screw, push the metal tab backwards, towards the fan, to release the front of the optical drive.

Étape 9  ¶ 

Lift the Bluetooth antenna board from the right side of the optical drive.

Étape 9  ¶ 

  • Lift the Bluetooth antenna board from the right side of the optical drive.

Étape 10  ¶ 

Pas d'image

Étape 10  ¶ 

  • Deroute the hard drive cable from along the front of the optical drive.

Étape 11  ¶ 

Lift the front edge of the optical drive and slide it up and out of the computer.

Étape 11  ¶ 

  • Lift the front edge of the optical drive and slide it up and out of the computer.