Aller au contenu principal
Aide

MacBook Pro 17" Unibody Battery Replacement

Tutoriel vedette

Tutoriel vedette

L'équipe iFixit trouve ce tutoriel particulièrement réussi.

Replace a worn-out battery on your MacBook Pro 17" Unibody.

  • Auteur: Andrew Bookholt
  • Durée estimée : 15 - 45 minutes
  • Difficulté: Modérée

Use this guide to replace your MacBook Pro's battery. Removing the battery requires a Tri-point screwdriver.

Étape 1 Battery  ¶ 

Whenever working near the logic board, it is always wise to first disconnect the battery to avoid short circuits. Grab the plastic tab attached to the battery connector and pull it toward the front edge of the device.

Étape 1 Battery  ¶ 

  • Whenever working near the logic board, it is always wise to first disconnect the battery to avoid short circuits.

  • Grab the plastic tab attached to the battery connector and pull it toward the front edge of the device.

  • Pull the tab parallel to the face of the logic board.

Étape 2  ¶ 

Remove the three 6.5 mm Tri-point screws securing the battery to the upper case.

Étape 2  ¶ 

  • Remove the three 6.5 mm Tri-point screws securing the battery to the upper case.

Étape 3  ¶ 

Use a plastic opening tool or another soft thin-edged tool to carefully lift up a corner of the "Warning: Do not remove the battery" sticker off the right speaker/subwoofer enclosure. Peel the sticker off the right speaker/subwoofer enclosure.

Étape 3  ¶ 

  • Use a plastic opening tool or another soft thin-edged tool to carefully lift up a corner of the "Warning: Do not remove the battery" sticker off the right speaker/subwoofer enclosure.

  • Peel the sticker off the right speaker/subwoofer enclosure.

  • It is not necessary to completely peel the sticker off the battery.

Étape 4  ¶ 

Lift the battery by its attached pull tab and remove it from the upper case.

Étape 4  ¶ 

  • Lift the battery by its attached pull tab and remove it from the upper case.

  • If you're installing a new battery, you should calibrate it after installation:

  • Charge it to 100%, and then keep charging it for at least 2 more hours. Next, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.