Aller au contenu principal
Aide

Canon PowerShot SD200 Buttons Replacement

Police de grammaire

Police de grammaire

Réveillez le prof qui sommeille en vous et aidez-nous à améliorer l'orthographe de ce tutoriel !

This guide will show you how to remove the buttons on the Canon PowerShot SD200.

  • Auteur: James Loy
  • Durée estimée : 10 - 15 minutes
  • Difficulté: Facile

Removing the buttons might be necessary if a button is damaged. This guide will show how to remove all external buttons on the camera.

Sections
Outils

Étape 1 Buttons  ¶ 

Close light gray battery compartment door. Remove the six 2.8 mm Phillips screws on the outside of the case. Two screws are found on each side of the camera, and the final two are found on the bottom. Remove the six 2.8 mm Phillips screws on the outside of the case. Two screws are found on each side of the camera, and the final two are found on the bottom.

Étape 1 Buttons  ¶ 

  • Close light gray battery compartment door.

  • Remove the six 2.8 mm Phillips screws on the outside of the case. Two screws are found on each side of the camera, and the final two are found on the bottom.

Étape 2  ¶ 

Use your fingers to carefully pry off the back casing from the camera assembly. Casing should lift straight off. Use your fingers to carefully pry off the back casing from the camera assembly. Casing should lift straight off.

Étape 2  ¶ 

  • Use your fingers to carefully pry off the back casing from the camera assembly. Casing should lift straight off.

Étape 3  ¶ 

Push the buttons out with your finger if they did not fall out while removing the casing. Pull off the white plastic side piece if it did not fall out while removing the casing. Pull off the white plastic side piece if it did not fall out while removing the casing.

Étape 3  ¶ 

  • Push the buttons out with your finger if they did not fall out while removing the casing.

  • Pull off the white plastic side piece if it did not fall out while removing the casing.

Étape 4  ¶ 

Remove the one 2.2 mm Phillips screw from the bottom of the camera. Take off the print button.

Étape 4  ¶ 

  • Remove the one 2.2 mm Phillips screw from the bottom of the camera.

  • Take off the print button.

Étape 5  ¶ 

Use your fingers to carefully pry off the front casing of the camera. The front casing should pull straight off. Use your fingers to carefully pry off the front casing of the camera. The front casing should pull straight off.

Étape 5  ¶ 

  • Use your fingers to carefully pry off the front casing of the camera. The front casing should pull straight off.

Étape 6  ¶ 

Use the flat end of the spudger to lift open the white plastic latch on the front of the camera. Once the latch is lifted up, move the latch up towards the top edge of the camera. Remove the top button assembly by pulling straight up.

Étape 6  ¶ 

  • Use the flat end of the spudger to lift open the white plastic latch on the front of the camera. Once the latch is lifted up, move the latch up towards the top edge of the camera.

  • Remove the top button assembly by pulling straight up.