Aller au contenu principal
Aide

iPod 3rd Generation Battery Replacement

Tutoriel vedette

Tutoriel vedette

L'équipe iFixit trouve ce tutoriel particulièrement réussi.

  • Auteur: iRobot
  • Durée estimée : 45 minutes
  • Difficulté: Modérée

Battery not lasting long? Swap it out.

Pièces utiles

Étape 1 Battery  ¶ 

Lift up the hard drive with one hand and carefully disconnect the hard drive ribbon from the logic board.

Étape 1 Battery  ¶ 

  • Lift up the hard drive with one hand and carefully disconnect the hard drive ribbon from the logic board.

  • Lift the hard drive out of the iPod.

Étape 2  ¶ 

Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.

Étape 2  ¶ 

  • Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.

Étape 3  ¶ 

Removing the following screw isn't strictly necessary, but it will make the next step easier.

Étape 3  ¶ 

  • Removing the following screw isn't strictly necessary, but it will make the next step easier.

  • Remove the black T6 Torx screw from near the battery connector on the logic board.

Étape 4  ¶ 

Carefully thread the battery cable around the end of the logic board. Be careful not to pull up on the logic board too much while freeing the battery cable.

Étape 4  ¶ 

  • Carefully thread the battery cable around the end of the logic board. Be careful not to pull up on the logic board too much while freeing the battery cable.

Étape 5  ¶ 

Lift the battery up and out of the iPod.

Étape 5  ¶ 

  • Lift the battery up and out of the iPod.