Aller au contenu principal
Aide

Nikon Coolpix L18 Lens Replacement

Problème de balisage

Problème de balisage

Ce tutoriel nécessite de meilleures balises. Améliorez-le par des corrections ou des annotations de balisage.

Tutoriel vedette

Tutoriel vedette

L'équipe iFixit trouve ce tutoriel particulièrement réussi.

Replace the Lens in your Nikon Coolpix L18.

  • Auteur: Andrea Govea
  • Durée estimée : 10 - 15 minutes
  • Difficulté: Difficile

In this guide, we will give you step-by-step instructions on how to detach the lens from the logic board so that it can be replaced or repaired.

Sections
Outils

Étape 1 Lens  ¶ 

Remove the 6 screws anchoring the LCD base to the logic board using the Phillips #00 screwdriver. Remove the LCD base plate.

Étape 1 Lens  ¶ 

  • Remove the 6 screws anchoring the LCD base to the logic board using the Phillips #00 screwdriver.

  • Remove the LCD base plate.

Étape 2  ¶ 

Lift the black latch connecting the LCD ribbon to the logic board.

Étape 2  ¶ 

  • Lift the black latch connecting the LCD ribbon to the logic board.

  • Gently pull the lens ribbon out.

Étape 3  ¶ 

Desolder the connection of the logic board to the lens ribbon using a soldering iron and desoldering wick.

Étape 3  ¶ 

  • Desolder the connection of the logic board to the lens ribbon using a soldering iron and desoldering wick.

  • You will need to have the soldering equipment specified to complete this step.

Étape 4  ¶ 

Lift up the black and copper covering on the left side of the camera.

Étape 4  ¶ 

  • Lift up the black and copper covering on the left side of the camera.

Étape 5  ¶ 

Pull the wiring at the top right of the camera away from the lens with tweezers.

Étape 5  ¶ 

  • Pull the wiring at the top right of the camera away from the lens with tweezers.

Étape 6  ¶ 

Remove the cross-hair shaped wire cap to the left of the lens.

Étape 6  ¶ 

  • Remove the cross-hair shaped wire cap to the left of the lens.

Étape 7  ¶ 

Remove the 3 screws holding the lens to the camera frame. Two 3.8mm black Phillips #00 screws on the sides of the lens.

Étape 7  ¶ 

  • Remove the 3 screws holding the lens to the camera frame.

  • Two 3.8mm black Phillips #00 screws on the sides of the lens.

  • One 4.6mm silver Phillips #00 screw on the bottom of the lens.

Étape 8  ¶ 

There is a screw behind flash tube holding lens. Remove it, then gently pull the lens out. Be sure that the lens's ribbon clears the logic board.

Étape 8  ¶ 

  • There is a screw behind flash tube holding lens. Remove it, then gently pull the lens out. Be sure that the lens's ribbon clears the logic board.