Aller au contenu principal
Aide

MacBook Pro 15" Core 2 Duo Model A1211 Display Assembly Replacement

Tutoriel vedette

Tutoriel vedette

L'équipe iFixit trouve ce tutoriel particulièrement réussi.

  • Auteur: iRobot
  • Durée estimée : 30 minutes - 1 heure
  • Difficulté: Modérée

Change out the entire display assembly, including the inverter, Airport antennas, hinges and casing.

Sections
Outils

Étape 1 Display Assembly  ¶ 

Disconnect the three antenna cables attached to the Airport Extreme card.

Étape 1 Display Assembly  ¶ 

  • Disconnect the three antenna cables attached to the Airport Extreme card.

  • Apple was kind enough to include a label showing where each color antenna cable plugs in - just make sure to look at this when reconnecting the antenna cables.

Étape 2  ¶ 

Deroute the Airport antenna cables from their channel in the left speaker.

Étape 2  ¶ 

  • Deroute the Airport antenna cables from their channel in the left speaker.

Étape 3  ¶ 

Disconnect the iSight cable from the logic board by sliding the cable to the left and out of its connector.

Étape 3  ¶ 

  • Disconnect the iSight cable from the logic board by sliding the cable to the left and out of its connector.

Étape 4  ¶ 

Disconnect the inverter cable from the logic board by placing a spudger beneath the cable and lifting up.

Étape 4  ¶ 

  • Disconnect the inverter cable from the logic board by placing a spudger beneath the cable and lifting up.

Étape 5  ¶ 

Disconnect the display data cable from the logic board by pulling sideways.

Étape 5  ¶ 

  • Disconnect the display data cable from the logic board by pulling sideways.

Étape 6  ¶ 

Remove the silver T6 Torx securing the ground loop in the display data cable to the casing.

Étape 6  ¶ 

  • Remove the silver T6 Torx securing the ground loop in the display data cable to the casing.

Étape 7  ¶ 

Support the display with one hand while removing the following 3 screws:

Étape 7  ¶ 

  • Support the display with one hand while removing the following 3 screws:

  • Two 9.5 mm silver T6 Torx screws with threads on only part of the shaft on the inside of the display hinges.

  • One 9.5 mm silver T6 Torx screw with threads on the entire shaft on the outside of the left hinge.

Étape 8  ¶ 

Grasp the display assembly on both sides and lift it up and out of the computer.

Étape 8  ¶ 

  • Grasp the display assembly on both sides and lift it up and out of the computer.