Aller au contenu principal
Aide

Sony Handycam DCR-DVD103 Laser Disc Replacement

This guide will tell how to access and replace the laser bay in the Sony Handycam DCR-DVD103.

  • Auteur: Lauren
  • Difficulté: Modérée

Occasionally, the laser eye will break or no longer move along the track. In this handycam, the laser eye is not replaceable by itself, but the laser bay may be swapped.

Sections
Outils

Étape 1 Laser Disc  ¶ 

Remove (1) 2.9mm screw from under the eye piece. Remove (1) 2.9mm screw from above the eye piece. Remove (4) copper strips from bellow the eye piece.

Étape 1 Laser Disc  ¶ 

  • Remove (1) 2.9mm screw from under the eye piece.

  • Remove (1) 2.9mm screw from above the eye piece.

  • Remove (4) copper strips from bellow the eye piece.

  • Pull off the eye piece assembly.

Étape 2  ¶ 

Pull off back cover. Caution: Be careful not to tear any copper strips in the process.

Étape 2  ¶ 

  • Pull off back cover. Caution: Be careful not to tear any copper strips in the process.

  • Remove (4) copper strips in order to pull off eye piece.

Étape 3  ¶ 

Remove (4) 3.6mm wide head screws on the laser reader.

Étape 3  ¶ 

  • Remove (4) 3.6mm wide head screws on the laser reader.

  • Note: There are rubber rings around screws that easily fall off.

Étape 4  ¶ 

Unplug copper strip and lift up. Pull off tape over 2.3mm screw. Remove (1) 2.3mm screw from under the tape.

Étape 4  ¶ 

  • Unplug copper strip and lift up.

  • Pull off tape over 2.3mm screw.

  • Remove (1) 2.3mm screw from under the tape.

Étape 5  ¶ 

Pull the copper strip, marked by the red rectangle, through the hole behind it, marked with the yellow rectangle. Pull the copper strip, marked by the red rectangle, through the hole behind it, marked with the yellow rectangle.

Étape 5  ¶ 

  • Pull the copper strip, marked by the red rectangle, through the hole behind it, marked with the yellow rectangle.

Étape 6  ¶ 

Remove (3) 2.9mm screws from top circuit board. Note: Circuit board will resist trying to be pulled off so pull it off with care but still firmly. Lift up circuit board and remove (1) 2.9mm screw underneath.

Étape 6  ¶ 

  • Remove (3) 2.9mm screws from top circuit board.

  • Note: Circuit board will resist trying to be pulled off so pull it off with care but still firmly.

  • Lift up circuit board and remove (1) 2.9mm screw underneath.

  • Pull out copper plate with rubber insulator on it.

Étape 7  ¶ 

Remove tape over copper strip in the bottom left corner and pull out copper strip. Remove laser reader assembly. Remove laser reader assembly.

Étape 7  ¶ 

  • Remove tape over copper strip in the bottom left corner and pull out copper strip.

  • Remove laser reader assembly.