Aller au contenu principal
Aide

Sony CCD-TR81 Lens Assembly Replacement

Problème de balisage

Problème de balisage

Ce tutoriel nécessite de meilleures balises. Améliorez-le par des corrections ou des annotations de balisage.

Texte bizarre

Texte bizarre

Certaines parties de ce texte sont confuses, répétitives ou hors-sujet. Modifie-les pour les rendre plus claires !

This guide will show how to access and install the lens assembly by removing all of the surrounding components of the video camera.

  • Auteur: Andrew
  • Durée estimée : 50 minutes - 1 heure
  • Difficulté: Difficile

If the lens of the video camera cracks or becomes cloudy, replacing it can be costly and confusing. This guide shows how you can access the lens assembly on your own to make a quick replacement. To get to the lens assembly, you will need to have already removed the battery and the outer casing.

Étape 1 Lens Assembly  ¶ 

Remove three screws from the circuit board on the left side of the video camera 3x3.6mm.

Étape 1 Lens Assembly  ¶ 

  • Remove three screws from the circuit board on the left side of the video camera 3x3.6mm.

Étape 2  ¶ 

Using metal tweezers, pull out the plastic connector box. Pull up the circuit board. Be careful, it should still be connected to a band wire.

Étape 2  ¶ 

  • Using metal tweezers, pull out the plastic connector box.

  • Pull up the circuit board. Be careful, it should still be connected to a band wire.

Étape 3  ¶ 

Remove three 2x4.45mm 1x5.36mm screws around lens assembly. Remove three 2x4.45mm 1x5.36mm screws around lens assembly. Remove three 2x4.45mm 1x5.36mm screws around lens assembly.

Étape 3  ¶ 

  • Remove three 2x4.45mm 1x5.36mm screws around lens assembly.

Étape 4  ¶ 

Remove three screws from the bottom part of the lens assembly 2x6.00mm and 1x5.46mm. Be careful not to break band wires. The bottom two are gold screws.

Étape 4  ¶ 

  • Remove three screws from the bottom part of the lens assembly 2x6.00mm and 1x5.46mm. Be careful not to break band wires. The bottom two are gold screws.

Étape 5  ¶ 

Lift lens assembly off large circuit board. Unscrew three top screws 2x5.31mm and 1x6.07mm.

Étape 5  ¶ 

  • Lift lens assembly off large circuit board.

  • Unscrew three top screws 2x5.31mm and 1x6.07mm.

  • Unscrew last remaining screw with Phillips #000 screwdriver 1x6.06mm. Lens should detach from lens assembly.

Étape 6  ¶ 

Once lens has been removed from lens assembly, replacement or repair is possible.

Étape 6  ¶ 

  • Once lens has been removed from lens assembly, replacement or repair is possible.