Aller au contenu principal
Aide

Motorola Slvr L7 Front Panel Replacement

Police de grammaire

Police de grammaire

Réveillez le prof qui sommeille en vous et aidez-nous à améliorer l'orthographe de ce tutoriel !

Outils incorrects

Outils incorrects

Participez à l'amélioration de ce tutoriel en utilisant les outils adaptés dans les photos et/ou le texte.

Step-by-Step process of installing HTC Front Panel

  • Auteur: Jorge Trujillo
  • Durée estimée : 15 - 25 minutes
  • Difficulté: Modérée

Étape 1 Front Panel  ¶ 

Push down on the black tab located at the top center of the Motorola phone

Étape 1 Front Panel  ¶ 

  • Push down on the black tab located at the top center of the Motorola phone

Étape 2  ¶ 

Remove the battery by pulling the battery from the top center.

Étape 2  ¶ 

  • Remove the battery by pulling the battery from the top center.

Étape 3  ¶ 

Remove the four T6 2 mm TX Torx screws

Étape 3  ¶ 

  • Remove the four T6 2 mm TX Torx screws

Étape 4  ¶ 

Insert the flat end of a plastic opening tool and pry the metal cover up off the phone. Insert the flat end of a plastic opening tool and pry the metal cover up off the phone.

Étape 4  ¶ 

  • Insert the flat end of a plastic opening tool and pry the metal cover up off the phone.

Étape 5  ¶ 

Carefully, disconnect the two connectors from their sockets on the motherboard using the flat end of a plastic opening tool. Carefully, disconnect the two connectors from their sockets on the motherboard using the flat end of a plastic opening tool.

Étape 5  ¶ 

  • Carefully, disconnect the two connectors from their sockets on the motherboard using the flat end of a plastic opening tool.

Étape 6  ¶ 

Use a plastic opening tool to pry the antenna cable connectors from its respective socket on the motherboard.

Étape 6  ¶ 

  • Use a plastic opening tool to pry the antenna cable connectors from its respective socket on the motherboard.

  • De-route the antenna cable by pulling it out.

Étape 7  ¶ 

Use a spudger to lift and remove the black plastic screw cover at the bottom of the phone near the speaker

Étape 7  ¶ 

  • Use a spudger to lift and remove the black plastic screw cover at the bottom of the phone near the speaker

  • The cover is attached by adhesive, so some force may be required.

Étape 8  ¶ 

Insert the flat end of a spudger and pry the frame off the phone. The frame is attached by adhesive, so some force may be required

Étape 8  ¶ 

  • Insert the flat end of a spudger and pry the frame off the phone.

  • The frame is attached by adhesive, so some force may be required