Aller au contenu principal
Aide

HP Photosmart c3180 Scanner Glass Replacement

Problème de balisage

Problème de balisage

Ce tutoriel nécessite de meilleures balises. Améliorez-le par des corrections ou des annotations de balisage.

Replacing that cracked or scratched scanner glass.

  • Auteur: Jim
  • Durée estimée : 10 minutes
  • Difficulté: Facile

Étape 1 Scanner Glass  ¶ 

Set aside the printer body. Unscrew the T10 12 mm Torx screw.

Étape 1 Scanner Glass  ¶ 

  • Set aside the printer body.

  • Unscrew the T10 12 mm Torx screw.

  • Remove the plastic tab holding the glass in place.

  • Carefully lift the scanner glass panel above the plastic barrier and pull it towards the control panel circuitry. It can take quite a bit of force to get the panel to slide out. If not removed carefully, the scanner glass can shatter

Étape 2  ¶ 

Slide the new panel of glass in to the tabs on the right side of the top panel. Place your thumb on top of the tab at the top of the panel. grip the outside edge of the panel and roll outward, allowing the scanner glass panel to fall into place.

Étape 2  ¶ 

  • Slide the new panel of glass in to the tabs on the right side of the top panel.

  • Place your thumb on top of the tab at the top of the panel. grip the outside edge of the panel and roll outward, allowing the scanner glass panel to fall into place.

Étape 3  ¶ 

Reattach the plastic piece which holds the scanner glass down and the 2.74 mm Torx screw.

Étape 3  ¶ 

  • Reattach the plastic piece which holds the scanner glass down and the 2.74 mm Torx screw.