Aller au contenu principal
Aide

HP Photosmart c3180 Scanner Bulb Replacement

Problème de balisage

Problème de balisage

Ce tutoriel nécessite de meilleures balises. Améliorez-le par des corrections ou des annotations de balisage.

Replacing a burnt out of broken scanner bulb.

  • Auteur: Jim
  • Durée estimée : 10 - 15 minutes
  • Difficulté: Modérée

Étape 1 Scanner Bulb  ¶ 

Set aside the top panel of the printer. Lift the scanner carriage vertically, being careful not to yank of the cables connecting it to the printer.

Étape 1 Scanner Bulb  ¶ 

  • Set aside the top panel of the printer.

  • Lift the scanner carriage vertically, being careful not to yank of the cables connecting it to the printer.

Étape 2  ¶ 

Flip the scanner carriage over to expose the connectors on the bottom. Carefully remove the small cable from the connector.

Étape 2  ¶ 

  • Flip the scanner carriage over to expose the connectors on the bottom.

  • Carefully remove the small cable from the connector.

  • Carefully remove the large cable from the connector.

Étape 3  ¶ 

Remove the scanner carriage from the scanner tray and flip it upside down. Remove the two T10 12mm Torx screws.

Étape 3  ¶ 

  • Remove the scanner carriage from the scanner tray and flip it upside down.

  • Remove the two T10 12mm Torx screws.

  • Remove the scanner carriage from the scanner bulb.