Introduction

Replacing the plastic bottom case.

Use a coin to rotate the battery locking screw 90 degrees clockwise.
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  • Lift the battery out of the computer.

Ajouter un commentaire

Use a pin to remove the three rubber feet from the lower case.
  • Use a pin to remove the three rubber feet from the lower case.

Ajouter un commentaire

  • Remove the three newly-revealed Phillips screws.

Ajouter un commentaire

  • Use a spudger or small flathead screwdriver to pry up the three metal rings that housed the rubber bumpers.

Ajouter un commentaire

  • Remove the three hex screws using a T8 Torx screwdriver.

  • The screw in the center is shorter than the other two.

Ajouter un commentaire

  • Remove the two Phillips screws on either side of the battery contacts.

Ajouter un commentaire

  • Breathe deeply. Trying times are ahead, but we promise the lower case does come off.

  • Push the thin rims of the lower case surrounding the battery compartment in, bending them past the tabs, and then lift up to free that corner of the lower case.

Ajouter un commentaire

  • There is a slot on the wall of the battery compartment that locks the lower case in place.

  • Use a small flathead screwdriver to pry out the slot's lower rim and pull up on the lower case to free the slot from the tabs holding it.

Ajouter un commentaire

  • Run a spudger along the seam between the lower case and upper case on the front of the computer to free the tabs locking the lower case.

  • Pull up on the lower case and continue to use the spudger as necessary until you hear three distinct clicks.

Ajouter un commentaire

  • Continue to run the spudger around the front, right corner.

  • There are two tabs on the port side of the computer, one near the front corner and one near the sound out port.

Ajouter un commentaire

  • Once the front and sides of the lower case are free, turn the computer so that the back is facing you.

  • Pull the lower case up and toward you until the back tabs pop free.

  • It may be helpful to jiggle the case up and down.

Ajouter un commentaire

  • Remove the small greasy springs with white plastic caps from either side of the battery contacts.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Pièces jointes

iRobot

Membre depuis le 24/09/2009

1 Réputation

621 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 4,078