Menu 

Vos paramètres

Mon établi

Accédez rapidement aux tutoriels, aux pièces et aux réponses correspondant à vos appareils
Mon panier (US Store)

On dirait que votre panier est vide

Parcourez notre boutique

iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement

Rédigé par : Andrew Bookholt (et 5 autres contributeurs)
  • Commentaires : 1
  • Favoris : 0

Difficulté

Modérée

Étapes

7

Sections

1

Drapeaux

1

Prerequisite Only

Conditions préalables uniquement

Notez qu'il ne s'agit que de conditions préalables pour d'autres tutoriels.

Introduction

This guide is an internal private guide that serves as a prereq.

Outils

Acheter ces outils

Pièces

Aucune pièce spécifiée.

  1. Remove the large piece of tape near the lower right corner of the display.

    • Remove the large piece of tape near the lower right corner of the display.

    Traduire

  2. Remove the single screw inserted through the piece of EMI tape near the bottom edge of the display (it's the first of the two clutch cover screws). Use the tip of a spudger to remove the small washer under the screw you just removed.

    • Remove the single screw inserted through the piece of EMI tape near the bottom edge of the display (it's the first of the two clutch cover screws).

    • Use the tip of a spudger to remove the small washer under the screw you just removed.

    Traduire

  3. Peel the aluminum/EMI tape as one piece off the cast aluminum frame of the clutch hinges.

    • Peel the aluminum/EMI tape as one piece off the cast aluminum frame of the clutch hinges.

    • It is not necessary to peel the tape off the thin steel LCD cover.

    Traduire

  4. Kits pour Apple Watch

    Réparer l'écran et la batterie n'a jamais été aussi facile.

    Acheter maintenant

    Kits pour Apple Watch

    Réparer l'écran et la batterie n'a jamais été aussi facile.

    Acheter maintenant

  5. Remove the pieces of readily removable tape from around the perimeter of the display.

    • Remove the pieces of readily removable tape from around the perimeter of the display.

    Traduire

  6. Remove the piece of aluminum tape near the center of the LCD cover. Peel back the piece of tape securing the display data cable ground loop to the thin steel LCD cover.

    • Remove the piece of aluminum tape near the center of the LCD cover.

    • Peel back the piece of tape securing the display data cable ground loop to the thin steel LCD cover.

    Traduire

  7. Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total). Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total).

    • Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total).

    Traduire

  8. Lift the thin steel LCD cover off the LCD.

    • Lift the thin steel LCD cover off the LCD.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 commentaires

Ajouter un commentaire

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 454