Introduction

Replacing this keyboard is easy and takes only a few minutes.

Use a coin to rotate the battery locking screw 90 degrees clockwise.
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

Ajouter un commentaire

Lift the battery out of the computer.
  • Lift the battery out of the computer.

Ajouter un commentaire

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

  • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

  • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

Ajouter un commentaire

  • If the computer has an AirPort card installed, follow the next three steps to remove it.

  • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

Ajouter un commentaire

  • Grasp the clear plastic tab on the AirPort card and pull toward the display.

Ajouter un commentaire

  • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

Ajouter un commentaire

  • Remove the four silver Phillips screws that secure the RAM shield.

Ajouter un commentaire

  • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

Ajouter un commentaire

  • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

  • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Pièces jointes

iRobot

Membre depuis le 24/09/2009

1 Réputation

621 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 5

Total : 11,688