Réparez vos affaires Communauté Boutique

iMac G4 17 800 MHz EMC 1936 Bottom Plate Housing Replacement

Introduction

Remove bottom housing to reveal the inside of the iMac.

Ce dont vous avez besoin

  1. iMac G4 17 800 MHz EMC 1936 Bottom Plate Housing Replacement, Bottom Plate: étape 1, image 1 de 1

    • Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

    Modifier

  2. iMac G4 17 800 MHz EMC 1936 Bottom Plate Housing Replacement: étape 2, image 1 de 1

    • Loosen the four Phillips #0 screws.

    Modifier

  4. iMac G4 17 800 MHz EMC 1936 Bottom Plate Housing Replacement: étape 3, image 1 de 1

    • Carefully remove the base access panel.

    Modifier

  5. iMac G4 17 800 MHz EMC 1936 Bottom Plate Housing Replacement, Bottom Plate Housing: étape 4, image 1 de 2 iMac G4 17 800 MHz EMC 1936 Bottom Plate Housing Replacement, Bottom Plate Housing: étape 4, image 2 de 2

    • Remove the four 25mm T-15 screws.

    Modifier

  6. iMac G4 17 800 MHz EMC 1936 Bottom Plate Housing Replacement: étape 5, image 1 de 2 iMac G4 17 800 MHz EMC 1936 Bottom Plate Housing Replacement: étape 5, image 2 de 2

    • Open the housing plate.

    • Be gentle with the wires still connected to the logic board so as not to ruin the cables.

    • A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autres ont terminé cette réparation.

Auteur

avec 7 autres contributeurs

Justin

Membre depuis le 10/05/11

303 Réputation

3 tutoriels rédigés

Badges: 10

+ 7 badges supplémentaires

Équipe

Cal Poly, Team 21-22, Maness Fall 2011 Membre de l'équipe Cal Poly, Team 21-22, Maness Fall 2011

CPSU-MANESS-F11S21G22

4 membres

13 tutoriels rédigés

Un commentaire

If you do this - don't you still need to apply a fresh coat of thermal paste to the exposed ends of the two heat-sink posts (that separate when you open a G4 flatpanel this far) - my understanding was that the machine would overheat and you'd be left with didley squat!!

Gregg :O)

amicuset - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 1

30 derniers jours : 5

Total : 2,142